HP Manager Software manual Syntax display log trace +-/number-of-messages

display log trace 585

display log trace Displays system information stored in the nonvolatile log buffer or the trace buffer.

Syntax — display log trace [{+-/}number-of-messages]

[facility facility-name] [matching string]

[severity severity-level]

„trace — Displays the log messages in the trace buffer.

„+-/number-of-messages— Displays the number of messages specified as follows:

„A positive number (for example, +100), displays that number of log entries starting from the oldest in the log.

„A negative number (for example, -100) displays that number of log entries starting from newest in the log.

„A number preceded by a slash (for example, /100) displays that number of the most recent log entries in the log, starting with the least recent.

„facility facility-name— Area of MSS that is sending the log message. Type a space and a question mark (?) after display log trace facility for a list of valid facilities.

„matching string — Displays messages that match a string—for example, a username or IP address.

„severity severity-level— Displays messages at a severity level greater than or equal to the level specified. Specify one of the following:

„emergency — The WX switch is unusable.

„alert — Action must be taken immediately.

„critical — You must resolve the critical conditions. If the conditions are not resolved, the WX can reboot or shut down.

„error — The WX is missing data or is unable to form a connection.

„warning — A possible problem exists.

„notice — Events that potentially can cause system problems have occurred. These are logged for diagnostic purposes. No action is required.

„info — Informational messages only. No problem exists.

„debug — Output from debugging.