HP Manager Software manual Set dap auto, Dap auto mode enable command

306CHAPTER 9: MANAGED ACCESS POINT COMMANDS

set dap auto	Creates a template for automatic configuration of Distributed MAPs.
	Syntax — set dap auto
	Defaults — None.
	Access — Enabled.
	History —Introduced in MSS 4.0.
	Usage — Table 65 lists the configurable template parameters and their
	defaults. The only parameter that requires configuration is the template
	mode. The template is disabled by default. To use the template to
	configure Distributed MAPs, you must enable the template using the set
	dap auto mode enable command.
	The template uses the default radio profile by default. You can change
	the profile using the set dap auto radio radio-profilecommand. You
	can use set dap auto commands to change settings for the parameters
	listed in Table 65. (The commands are listed in the “See Also” section.)

Table 65 Configurable Template Parameters for Distributed MAPs

Parameter	Default Value
MAP Parameters
mode	disabled
bias	high
upgrade-firmware	enable (YES)
(boot-download-enable)
group (load balancing group)	none
blink	disable
(Not shown in display dap config
output)
Radio Parameters
radiotype (type)	11g
(Applies only to single-radio MAP	(or 11b for country codes where
models)	802.11g is not allowed)
mode	enabled