HP Manager Software manual Commands

9	MANAGED ACCESS POINT
	COMMANDS

Use MAP access point commands to configure and manage MAP access points. Be sure to do the following before using the commands:

„Define the country-specific IEEE 802.11 regulations on the WX switch. (See set system countrycode on page 54.)

„Install the MAP access point and connect it to a port on the WX switch.

„Configure a MAP access port (for a directly connected MAP) or a Distributed MAP. (See set port type ap on page 87 and set dap on page 77.)

CAUTION: Changing the system country code after MAP configuration disables MAP access points and deletes their configuration. If you change the country code on a WX switch, you must reconfigure all MAP access points.

MAP Access Point This chapter presents MAP access point commands alphabetically. Use

Commands by Table 50 to locate commands in this chapter based on their use.

Usage

Table 50 Map Access Point Commands by Usage

Type	Command
Automatic	set dap auto on page 306
Configuration of
Distributed MAPs
	set dap auto mode on page 308
	set {ap dap} bias on page 310
	set {ap dap} blink on page 311
	set {ap dap} group on page 313