HP Manager Software manual Set service-profile auth-psk command

set service-profile shared-key-auth 363

set service-profileEnables shared-key authentication, in a service profile. shared-key-auth

Use this command only if advised to do so by 3Com. This command does not enable preshared key (PSK) authentication for Wi-Fi Protected Access (WPA). To enable PSK encryption for WPA, use the

set service-profile auth-psk command.

Syntax — set service-profile name shared-key-auth {enable disable}

„name — Service profile name.

„enable — Enables shared-key authentication.

„disable — Disables shared-key authentication.

Defaults — Shared-key authentication is disabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Examples — The following command enables shared-key authentication in service profile sp4:

WX4400# set service-profile sp4 shared-key-auth enable success: change accepted.

See Also

„display radio-profileon page 298

„set radio-profile mode on page 342

set service-profileConfigures the SSID name in a service profile. ssid-name

Syntax — set service-profile name ssid-name ssid-name

„name — Service profile name.

„ssid-name— Name of up to 32 alphanumeric characters. You can include blank spaces in the name, if you delimit the name with single or double quotation marks. You must use the same type of quotation mark (either single or double) on both ends of the string

Defaults — The default SSID name is private.