HP Manager Software manual Tune Channel

300CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Table 63 Output for display radio-profile (continued)

Field	Description
Long Preamble	Indicates whether an 802.11b radio that uses this radio
	profile advertises support for frames with long preambles
	only:
	„ YES — Advertises support for long preambles only.
	„ NO — Advertises support for long and short preambles.
Allow 802.11g	Indicates whether the 802.11b/g radios in the radio profile
clients only	restrict associations to 802.11g clients only:
	„ No — 802.11b/g radios allow associations with both
	802.11b and 802.11g clients.
	„ No — 802.11b/g radios allow associations with 802.11g
	clients only.
	Note: This field applies only to 802.11b/g radios.
Tune Channel	Indicates whether RF Auto-Tuning is enabled for dynamically
	setting and tuning channels.
Tune Power	Indicates whether RF Auto-Tuning is enabled for dynamically
	setting and tuning power levels.
Tune Channel	Interval, in seconds, at which RF Auto-Tuning decides
Interval	whether to change the channels on radios in a radio profile.
	At the end of each interval, MSS processes the results of the
	RF scans performed during the previous interval, and
	changes radio channels if needed.
Tune Power Interval	Interval, in seconds, at which RF Auto-Tuning decides
	whether to change the power level on radios in a radio
	profile. At the end of each interval, MSS processes the results
	of the RF scans performed during the previous interval, and
	changes radio power levels if needed.
Client Backoff Timer	Interval, in minutes, at which radios in a radio profile reduce
	power after temporarily increasing the power to maintain
	the minimum data rate for an associated client. At the end of
	each power-backoff interval, radios that temporarily
	increased their power reduce it by 1 dBm. The power
	backoff continues in 1 dBm increments after each interval
	until the power returns to expected setting.
Channel Holddown	Minimum number of seconds a radio in a radio profile must
	remain at its current channel assignment before
	RF Auto-Tuning can change the channel.