HP Manager Software Set port poe, Access points, Result, Following command enables PoE on ports 4

84CHAPTER 4: PORT COMMANDS

set port poe	Enables or disables Power over Ethernet (PoE) on ports connected to MAP
	access points.
	CAUTION: When you set the port type for MAP use, you can enable PoE
	on the port. Use the WX switch’s PoE to power 3Com MAP access points
	only. If you enable PoE on ports connected to other devices, damage can
	result.

Syntax — set port poe port-listenable disable

„port-list— List of physical ports. MSS disables or reenables PoE on all the specified ports.

„enable — Enables PoE on the specified ports.

„disable — Disables PoE on the specified ports.

Defaults — PoE is disabled on network and wired authentication ports. The state on MAP access point ports depends on whether you enabled or disabled PoE when setting the port type. See set port type ap on page 87.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — This command does not apply to any gigabit Ethernet ports or to ports 7 and 8 on the WX1200 switch.

Examples — The following command disables PoE on ports 4 and 5, which are connected to an MAP access point:

WX1200# set port poe 4,5 disable

If you are enabling power on these ports, they must be connected only to approved PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

The following command enables PoE on ports 4 and 5:

WX1200# set port poe 4,5 enable

If you are enabling power on these ports, they must be connected only to approved PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

See Also

„set port type ap on page 87

„set port type wired-authon page 91