HP Manager Software Set ip route, WX switch is disabled, Syntax set ip route default ip-addr mask

150CHAPTER 6: IP SERVICES COMMANDS

set ip https server Enables the HTTPS server on a WX switch. The HTTPS server is required for Web Manager access to the switch.

CAUTION: If you disable the HTTPS server, Web Manager access to the

WX switch is disabled.

Syntax — set ip https server {enable disable}

„enable — Enables the HTTPS server.

„disable — Disables the HTTPS server.

Defaults — The HTTPS server is disabled by default.

Access — Enabled.

History — The default is changed to disabled in 3.1. In addition, the

HTTPS server is no longer required for WebAAA.

Examples — The following command enables the HTTPS server on a WX switch:

WX1200# set ip https server enable success: change accepted.

See Also

„clear ip telnet on page 119

„display ip https on page 129

„display ip telnet on page 133

„set ip telnet on page 156

„set ip telnet server on page 157

set ip route Adds a static route to the IP route table.

Syntax — set ip route {default ip-addr mask

ip-addr/mask-length}gateway metric

„default — Default route. A WX switch uses the default route if an explicit route is not available for the destination.

Default is an alias for IP address 0.0.0.0/0.