HP Manager Software manual SNMPv3 with Traps, Usm trap user username

set snmp notify target 163

„security — Specifies the security level, and is applicable only when the SNMP version is usm:

„unsecured — Message exchanges are not authenticated, nor are they encrypted. This is the default.

„authenticated — Message exchanges are authenticated, but are not encrypted.

„encrypted — Message exchanges are authenticated and encrypted.

„retries num — Specifies the number of times the MSS SNMP engine will resend a notification that has not been acknowledged by the target. You can specify from 0 to 3 retries.

„timeout num — Specifies the number of seconds MSS waits for acknowledgement of a notification. You can specify from 1 to 5 seconds.

SNMPv3 with Traps

To configure a notification target for traps from SNMPv3, use the following command:

Syntax — set snmp notify target target-num

ip-addr[:udp-port-number]

usm trap user username

[profile profile-name]

[security {unsecured authenticated encrypted}]

„target-num— ID for the target. This ID is local to the WX switch and does not need to correspond to a value on the target itself. You can specify a number from 1 to 10.

„ip-addr[:udp-port-number]— IP address of the server. You also can specify the UDP port number to send notifications to.

„username — USM username. This option is applicable only when the SNMP version is usm.

„profile profile-name— Notification profile this SNMP user will use to specify the notification types to send or drop.

„security {unsecured authenticated encrypted} — Specifies the security level, and is applicable only when the SNMP version is usm: