HP Manager Software set {ap | dap} radio channel

320CHAPTER 9: MANAGED ACCESS POINT COMMANDS

A radio also can increase power, in 1 dBm increments, if a client falls below the minimum allowed data rate. After a radio increases power, all clients must be at the minimum data rate or higher and the maximum retransmissions must be within the allowed percentile, before the radio begins reducing power again.

Examples — The following command changes the max-retransmissions value to 20:

WX1200# set ap 6 radio 1 auto-tunemax-retransmissions 20 success: change accepted.

See Also

„set {ap dap} radio auto-tunemax-poweron page 317

„set radio-profileauto-tunepower-backoff- timer on page 333

„set radio-profileauto-tunepower-configon page 334

„set radio-profileauto-tunepower-intervalon page 335

set {ap dap} radio channel

Sets an MAP radio’s channel.

Syntax — set {ap port-listdap dap-num}radio {1 2}

channel channel-number

„ap port-list— List of ports connected to the MAP access points on which to set the channel.

„dap dap-num— Number of a Distributed MAP on which to set the channel.

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

„channel channel-number— Channel number. The valid channel numbers depend on the country of operation.

Defaults — The default channel depends on the radio type:

„The default channel number for 802.11b/g is 6.

„The default channel number for 802.11a is the lowest valid channel number for the country of operation.

Access — Enabled.