HP Manager Software manual Change, Syntax change

change 595

change	Changes parameters in the currently active boot profile. (For information
	about boot profiles, see display on page 599.)
	Syntax — change
	Defaults — The default boot type is c (compact flash). The default
	filename is default. The default flags setting is 0x00000000 (all flags
	disabled) and the default options list is run=nos;boot=0. The default
	device setting is the boot partition specified by the most recent set boot
	partition command typed at the Enabled level of the CLI, or boot 0 if the
	command has never been typed.
	Access — Boot prompt.
	History —Introduced in MSS Version 3.0.
	Usage — After you type the change command, the system interactively
	displays the current setting of each parameter and prompts you for the
	new setting. When prompted, type the new setting, press Enter to accept
	the current setting, or type . (period) to change the setting to its default
	value. To back up to the previous parameter, type - (hyphen).
	For information about each of the boot parameters you can set, see
	display on page 599.
	Examples — The following command enters the configuration mode for
	the currently active boot profile, changes the device to boot1, and leaves
	the other parameters with their current settings:
	boot> change
	Changing the default configuration is not recommended.
	Are you sure that you want to proceed? (y/n)
	BOOT TYPE:	[c]
	DEVICE:	[boot0:]boot1
	FILENAME:	[default]
	FLAGS:	[0x00000000]
	OPTIONS:	[run=nos;boot=0]

See Also

„boot on page 593

„create on page 596