HP Manager Software manual Trace Commands

19 TRACE COMMANDS

Use trace commands to perform diagnostic routines. While MSS allows you to run many types of traces, this chapter describes commands for those traces you are most likely to use. For a complete listing of the types of traces MSS allows, type the set trace ? command.

CAUTION: Using the set trace command can have adverse effects on system performance. 3Com recommends that you use the lowest levels possible for initial trace commands, and slowly increase the levels to get the data you need.

Commands by	This chapter presents trace commands alphabetically. Use Table 106 to
Usage	locate commands in this chapter based on their use.
	Table 106 Trace Commands by Usage
	Type	Command
	Trace	set trace sm on page 567
		set trace dot1x on page 566
		set trace authentication on page 564
		set trace authorization on page 565
		display trace on page 563
		save trace on page 564
		clear trace on page 562
		clear log trace on page 562