HP Manager Software manual Set radio-profile auto-tune channel-config

330CHAPTER 9: MANAGED ACCESS POINT COMMANDS

set radio-profileDisables or reenables active RF detection scanning on the MAP radios

active-scanmanaged by a radio profile. When active scanning is enabled, MAP radios look for rogue devices by sending probe any requests (probe requests with a null SSID name), to solicit probe responses from other access points.

Passive scanning is always enabled and cannot be disabled. During passive scanning, radios look for rogues by listening for beacons and probe responses.

Syntax — set radio-profile name active-scan {enable disable}

„name — Radio profile name.

„enable — Configures radios to actively scan for rogues.

„disable — Configures radios to scan only passively for rogues by listening for beacons and probe responses.

Defaults — Active scanning is enabled by default.

Access — Enabled.

History —Introduced in MSS Version 4.0.

Usage — You can enter this command on any WX switch in the Mobility

Domain. The command takes effect only on that switch.

Examples — The following command disables active scan in radio profile radprof3:

WX-1200# set radio-profile radprof3 active-scan disable success: change accepted.

set radio-profile auto-tune channel-config

Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the MAP radios in a radio profile.

Syntax — set radio-profile name auto-tune channel-config {enable disable}

„name — Radio profile name.