HP Manager Software manual Display auto-tune, Attributes, Syntax display auto-tune attributes

290CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Table 57 Output for display ap status (continued)

Field	Description
CPU info	Specifications and identification of the CPU.
	For MAP models MAP-352, MAP-341, and MAP-52, the ID
	portion of this field is not applicable.
Uptime	Amount of time since the MAP last rebooted using this link.
	Note: This field is displayed only when this link is the MAP
	access point’s primary link.
Radio 1 type	802.11 type and configuration state of the radio.
Radio 2 type	„ The configure succeed state indicates that the MAP has
	received configuration parameters for the radio and the
	radio is ready to accept client connections.
	„ For 802.11b/g radios, 802.11b protect indicates that the
	radio is in 802.11b protection mode and is therefore
	operating only at 802.11b rates.
	„ Sweep Mode indicates that a disabled radio is
	nonetheless participating in rogue detection scans. Even
	though this message appears only for disabled radios, all
	radios, enabled or disabled, participate in rogue
	detection.
	„ Countermeasures Enabled indicates that the radio is
	sending countermeasures packets to combat a rogue.
operational channel	The channel on which the radio is currently operating.
operational power	The power level at which the radio is currently operating.
base mac	Base MAC address of the radio.
bssid, ssid	SSIDs configured on the radio and their BSSIDs.

display auto-tune	Displays the current values of the RF attributes RF Auto-Tuning uses to
attributes	decide whether to change channel or power settings.
	Syntax — display auto-tune attributes
	[ap map-num[radio {1 2 all}]]

Syntax — display auto-tune attributes [dap dap-num[radio {1 2 all}]]

„map-num— MAP port connected to the MAP access point for which to display RF attributes.

„dap-num— Number of a Distributed MAP for which to display RF attributes.