HP Manager Software manual Data, Displays information about the APs detected by a WX switch

518CHAPTER 17: RF DETECTION COMMANDS

Table 95 display rfdetect countermeasures Output (continued)

	Field	Description
	Countermeasures	MAC address of the 3Com radio sending countermeasures
	Radio MAC	against the rogue.
		If the field value is Not Started, MSS has not started
		countermeasures against the rogue yet.
	WX-IPaddr	System IP address of the WX switch that is managing the
		MAP that is sending or will send countermeasures.
	Port/Radio/Channel	Port number, radio number, and channel number of the
		countermeasures radio. For a Distributed MAP, the
		connection number is labeled dap. (This stands for
		distributed ap.)
	See Also
	„ clear rfdetect attack-liston page 512
	„ set rf detect countermeasures on page 530
	„ set rfdetect countermeasures mac on page 530
display rfdetect	Displays information about the APs detected by a WX switch.

data

Syntax — display rfdetect data

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0.Vendor, Type and Flags fields added to MSS Version 4.0

Usage — You can enter this command on any WX switch in the Mobility Domain. The output applies only to the switch on which you enter the command. To display all devices that a specific 3Com radio has detected, even if the radio is managed by another WX switch, use the display rfdetect visible command.

To display rogue information for the entire Mobility Domain, use the display rfdetect mobility-domaincommand on the seed switch.

Only one MAC address is listed for each 3Com radio, even if the radio is beaconing multiple SSIDs.