HP Manager Software manual Set ap dap radio auto-tune min-client-rate, „ display ap dap config on

set {ap dap} radio auto-tune min-client-rate 321

History —Introduced in MSS Version 3.0.

Usage — You can configure a radio’s transmit power on the same command line. Use the tx-poweroption.

This command is not valid if dynamic channel tuning (RF Auto-Tuning) is enabled.

Examples — The following command configures the channel on the

802.11a radio on the MAP access point connected to port 5:

WX1200# set ap 5 radio 1 channel 36 success: change accepted.

The following command configures the channel and transmit power on the 802.11b/g radio on the MAP access point connected to port 1:

WX1200# set ap 1 radio 1 channel 1 tx-power 10 success: change accepted.

See Also

„“display {ap dap} config” on page 277

„set {ap dap} radio tx-poweron page 325

set {ap dap} radio auto-tune min-client-rate

Sets the minimum rate at which a radio is allowed to transmit traffic to clients. The radio automatically increases its transmit power when necessary to maintain at least the minimum rate with an associated client.

Syntax — set {ap port-list dap (dap-num auto}

radio {1 2} auto-tune min-client-rate rate

„ap port-list— List of ports connected to the MAP access points on which to set the minimum data rate.

„dap dap-num— Number of a Distributed MAP on which to set the minimum data rate.

„dap auto — Sets the maximum power for radios configured by the MAP configuration template. (See set dap auto on page 306.)

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)