HP Manager Software manual Set radio-profile auto-tune channel-holddown

set radio-profile auto-tune channel-holddown 331

„enable — Configures radios to dynamically select their channels when the radios are started.

„disable — Configures radios to use their statically assigned channels, or the default channels if unassigned, when the radios are started.

Defaults — Dynamic channel assignment is enabled by default.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — If you disable RF Auto-Tuning for channels, MSS does not dynamically set the channels when radios are first enabled and also does not tune the channels during operation.

If RF Auto-Tuning for channels is enabled, MSS does not allow you to manually change channels.

Examples — The following command disables dynamic channel tuning for radios in the rp2 radio profile:

WX4400# set radio-profile rp2 auto-tune channel-config disable

success: change accepted.

See Also

„set radio-profileauto-tunechannel-holddownon page 331

„set radio-profileauto-tunechannel-intervalon page 332

„set radio-profileauto-tunepower-configon page 334

set radio-profile auto-tune channel-holddown

Sets the minimum number of seconds a radio in a radio profile must remain at its current channel assignment before RF Auto-Tuning can change the channel. The channel holddown provides additional stability to the network by preventing the radio from changing channels too rapidly in response to spurious RF anomalies such as short-duration channel interference.

Syntax — set radio-profile name auto-tune channel-holddown

holddown

„name — Radio profile name.