HP Manager Software Usage, Access, Syntax, Access, History, History, See Also, Defaults, Examples, set ip telnet, „ set ip ssh on page, „ crypto generate key on page

156CHAPTER 6: IP SERVICES COMMANDS

	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — You must generate an SSH authentication key to use SSH.
	The maximum number of SSH sessions supported on a WX switch is
	eight. If Telnet is also enabled, the WX switch can have up to eight Telnet
	or SSH sessions, in any combination, and one Console session.
	See Also
	„ crypto generate key on page 451
	„ set ip ssh on page 153
	„ set ip ssh absolute-timeouton page 154
	„ set ip ssh idle-timeouton page 155
set ip telnet	Changes the TCP port number on which a wireless LAN switch listens for
	Telnet management traffic.
	CAUTION: f you change the Telnet port number from a Telnet session,
	MSS immediately ends the session. To open a new management session,
	you must Telnet to the WX switch with the new Telnet port number.

Syntax — set ip telnet port-num

„port-num— TCP port number.

Defaults — The default Telnet port number is 23.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Examples — The following command changes the Telnet port number on a WX switch to 5000:

WX4400# set ip telnet 5000 success: change accepted.