CHAPTER 1

Rear Panel Features

1 2

3

4

5

6

6

5

6

MINIMUM SPEAKER LOAD IMPEDANCE 4 OHMS

7

6

6

6

7

6

8 9

1. AUTO/ON/OFF Switch

Your Theater Grand Amplifier is designed with an automatic on/off circuit.

In the AUTO-ON position, the amplifier will automatically turn on if an audio signal is pres- ent at any of the inputs, or if it receives a 12 VDC input volt- age at the trigger inputs. The amplifier will automatically turn off after a few seconds if the trigger voltage is removed, or after approximately 30 minutes in the absence of an audio signal.

In the ON position, the ampli- fier is always on, regardless of input signals or 12 VDC trigger.

In the OFF position, the ampli- fier is always off, regardless of input signals or 12 VDC trigger.

See page 7 for details of the front panel LED status.

2. 12 VDC Trigger Input

Although the AUTO-ON signal sensing turn-on is adequate for most installations, the 12 VDC trigger inputs are offered as an optional way to turn on the amplifier.

The Sunfire Theater Grand II, III, IV and TGP-5 Processors have a com- patible 12 VDC trigger output (see page 11). This can be used to auto- matically turn on the amplifier when the processor is turned on.

1/8" mono mini jacks are provided for ease of installation, along with a terminal strip to allow more flexibility for custom-wired installations. The terminal strip and both mini jacks are internally connected in parallel, allow- ing 'daisy chaining' to turn on multiple amplifiers.

Any 1/8" miniplug mono or stereo interconnect cable will suffice to con- nect the trigger output of the Theater Grand Processor to the amplifier.

Do not exceed 18 VDC on this input. (CAUTION: Do not connect AC line voltage to this input!)

The voltage range for the trigger input is from 5 to 18 VDC. The input impedance is approximately 600 Ω (20 mA @ 12V).

3. RCA Inputs

Your Theater Grand Amplifier has three sets of inputs for each of the seven channels. Two are unbalanced RCA inputs and one is a balanced XLR type.

The two RCA inputs for each chan- nel are joined together internally, and either one can be connected to the corresponding output of your pream- plifier.

The second RCA input can be used as a daisy-chaining output, sending the preamplifier output signal to an- other channel or to another amplifier.

8

User's Manual

Page 8
Image 8
Sunfire TGA-7400(E), TGA-7200(E) manual Rear Panel Features, AUTO/ON/OFF Switch, VDC Trigger Input, RCA Inputs