Biamping Connections
Note: The remaining channels can be used to drive other speakers, or left unconnected. These connections have been omitted from this drawing and the one below for clarity. They can be connected as shown on pages 10 and 11.
CHAPTER 2
UNBALANCED | ||
PREAMP | ||
L | OUTPUTS | |
R | ||
| ||
From: Preamplifier main RCA outputs
To: Amplifier RCA inputs
From: Amplifier Front L/R RCA
To: Amplifier Rear L/R RCA inputs
+ - RIGHT TWEETER (CURRENT SOURCE)
MINIMUM SPEAKER LOAD
IMPEDANCE 4 OHMS
+ - | + - |
RIGHT | |
WOOFER | LEFT |
| WOOFER |
LOUDSP | |
| EAKERS |
+ - LEFT TWEETER (CURRENT SOURCE)
Biamping with an external crossover
If you have an external active crossover, you can greatly increase the efficiency of your system. The crossover will split the preamplifier output signals into two frequency ranges.
You can connect the crossover's low frequency outputs to the ampli- fier's rear channel inputs, and the crossover's higher frequency outputs to the amplifier's front channel inputs.
INPUT | |
R | L |
| |
LOW FREQ
RANGE
| UNBALANCED |
| |
PREAMP OUTPUTS | |||
| R | L |
|
|
| FULL FREQ | |
|
| RANGE | |
|
|
| ACTIVE EXTERNAL C |
|
|
| ROSSOVER |
LOW OUT | HIGH OUT | ||
|
| ||
R | L | R | L |
| |||
|
| ||
|
|
| HIGH FREQ |
|
|
| RANGE |
This is an efficient system because the channels only amplify signals with- in the frequency range of the speaker element they are driving. Little power is wasted.
Make sure that the crossover point of your active crossover is adjusted to match the crossover point of your speakers. Consult your speaker and crossover owner's manuals.
User's Manual
MINIMUM SPEAKER LOAD
IMPEDANCE 4 OHMS
+ - | + | - | + |
|
|
| |
RIGHT | - | + |
| ||||
RIGHT | - | ||||||
TWEETER | |||||||
WOOFER | LEFT | ||||||
(CURRENT | LEFT | ||||||
|
| WOOFER | |||||
SOURCE) |
|
| TWEETER | ||||
|
|
|
| ||||
|
| LOUDSPEAKERS |
| (CURRENT | |||
|
|
| SOURCE) | ||||
|
|
|
|
| |||
13
