HP Manager Software manual Set port trap, Set snmp profile command

86CHAPTER 4: PORT COMMANDS

„100 — Sets the port speed of a 10/100 Ethernet port to 100 Mbps and sets the operating mode to full-duplex.

„1000 — Sets the port speed of a gigabit Ethernet port to 1000 Mbps and sets the operating mode to full-duplex.

„auto — Enables a port to detect the speed and operating mode of the traffic on the link and set itself accordingly.

	Defaults — All ports are set to auto.
	Access — Enabled.
	History — Introduced in MSS Version 3.0.
	Examples — The following command sets the port speed on ports 1 and
	3 through 4 to 10 Mbps and sets the operating mode to full-duplex:
	WX1200# set port speed 1,3-4 10
set port trap	Enables or disables Simple Network Management Protocol (SNMP) linkup
	and linkdown traps on an individual port.
	Syntax — set port trap port-list{enable disable}
	„ port-list— List of physical ports.
	„ enable — Enables the Telnet server.
	„ disable — Disables the Telnet server.
	Defaults — SNMP linkup and linkdown traps are disabled by default.
	Access — Enabled.
	History — Introduced in MSS Version 3.0.
	Usage — The set port trap command overrides the global setting of the
	set snmp profile command.
	The set port type command does not affect the global trap information
	displayed by the display snmp configuration command. For example, if
	you globally enable linkup and linkdown traps but then disable the traps
	on a single port, the display snmp configuration command still
	indicates that the traps are globally enabled.