HP Manager Software manual WX4400# set radius client system-ipsuccess change accepted

470CHAPTER 14: RADIUS AND SERVER GROUP COMMANDS

Usage — The WX system IP address must be set before you use this command.

Examples — The following command sets the WX system IP address as the address of the RADIUS client:

WX4400# set radius client system-ipsuccess: change accepted.

See Also

„clear radius client system-ipon page 465

„set system ip-addresson page 57

set radius proxy Adds a RADIUS proxy entry for a third-party AP. The proxy entry specifies

clientthe IP address of the AP and the UDP port on which the WX switch listens for RADIUS traffic from the AP.

Syntax — set radius proxy client address ip-address[port udp-port-number]key string

„address ip-address— IP address of the third-party AP. Enter the address in dotted decimal notation.

„port udp-port-number— UDP port on which the WX switch listens for RADIUS traffic from the AP.

„key string — Password (shared secret key) the WX switch uses to authenticate and encrypt RADIUS communication.

Defaults — The default UDP port number is 1812.

Access — Enabled.

History —Introduced in MSS 4.0.

Usage — AAA for third-party AP users has additional configuration requirements. See the “Configuring AAA for Users of Third-Party APs” section in the “Configuring AAA for Network Users” chapter of the Wireless LAN Switch and Controller Configuration Guide.

Examples — The following command configures a RADIUS proxy entry for a third-party AP RADIUS client at 10.20.20.9, sending RADIUS traffic to the default UDP port 1812 on the WX: