HP Manager Software manual Connection, Display dap global command

294CHAPTER 9: MANAGED ACCESS POINT COMMANDS

„set radio-profileauto-tunechannel-intervalon page 332

„set radio-profileauto-tunepower-backoff- timer on page 333

„set radio-profileauto-tunepower-configon page 334

„set radio-profileauto-tunepower-intervalon page 335

display dap	Displays the system IP address of the WX switch that has the active data
connection	connection for a Distributed MAP.
	Syntax — display dap connection
	[dap-num serial-idserial-ID]
	„ dap-num— Number of a Distributed MAP for which to display
	information about its active connection.
	„ serial-idserial-ID— MAP access point serial ID.
	Defaults — None.
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — The serial-idparameter displays the active connection for the
	specified Distributed MAP even if that MAP is not configured on this WX
	switch. If you instead use the command with the dap-numparameter or
	without a parameter, connection information is displayed only for
	Distributed MAPs that are configured on this WX switch.
	If a Distributed MAP is configured on this WX switch (or another WX
	switch in the same Mobility Domain) but does not have an active
	connection, the command does not display information for the MAP. To
	show configured Distributed MAPs regardless of connection status, use
	the display dap global command.

Examples — The following command displays information for all Distributed

MAPs configured on this WX switch that have active connections:

WX1200# display		dap connection
Total number of		entries: 2		WX IP Address
DAP Serial Id			DAP IP Address
--- -----------			---------------	---------------
2	M9DE48B012F00		10.10.2.27	10.3.8.111
4	M9DE48B123400		10.10.3.34	10.3.8.111