HP Manager Software manual Syntax clear radio-profile name parameter

274CHAPTER 9: MANAGED ACCESS POINT COMMANDS

See Also

„set {ap dap} radio mode on page 323

„set {ap dap} radio radio-profileon page 324

„set port type ap on page 87

clear radio-profileRemoves a radio profile or resets one of the profile’s parameters to its default value.

Syntax — clear radio-profile name [parameter]

„name — Radio profile name.

„parameter — Radio profile parameter:

„beacon-interval

„dtim-interval

„frag-threshold

„long-retry

„max-rx-lifetime

„max-tx-lifetime

„preamble-length

„rts-threshold

„service-profile

„short-retry

(For information about these parameters, see the set radio-profilecommands that use them.)

Defaults — If you reset an individual parameter, the parameter is returned to the default value listed in Table 66 on page 342.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — If you specify a parameter, the setting for the parameter is reset to its default value. The settings of the other parameters are unchanged and the radio profile remains in the configuration. If you do not specify a parameter, the entire radio profile is deleted from the configuration. All radios that use this profile must be disabled before you can delete the profile.