HP Manager Software manual Set port speed, Changes the speed of a port

set port preference 85

set port preference Configures a gigabit Ethernet port on a WX4400 to use the RJ-45 (copper) interface, when available, as the active link instead of the fiber interface.

Syntax — set port preference port-listrj45

„port-list— List of physical ports. MSS sets the preference on all the specified ports.

„rj45 — Prefers the copper interface.

Defaults — When both the copper and fiber interfaces of a gigabit

Ethernet port are connected, the GBIC (fiber) interface is the active link.

The RJ-45 (copper) link is unused.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — This command applies only to the WX4400.

If you set the preference to RJ-45 (copper) on a port that already has an active fiber link, MSS immediately changes the link to the copper interface.

Examples — The following command sets the preference of port 2 on a

WX4400 to RJ-45 (copper):

WX4400# set port preference 2 rj45

See Also

„clear port preference on page 64

„display port preference on page 69

set port speed Changes the speed of a port.

Syntax — set port speed port-list{10 100 1000 auto}

„port-list— List of physical ports. MSS sets the port speed on all the specified ports.

„10 — Sets the port speed of a 10/100 Ethernet port to 10 Mbps and sets the operating mode to full-duplex.