HP Manager Software manual See Also

588CHAPTER 21: SYSTEM LOG COMMANDS

If you do not specify a local facility, MSS sends the messages with their default MSS facilities. For example, AAA messages are sent with facility 4 and boot messages are sent with facility 20 by default.

„enable — Enables messages to the specified target.

„disable — Disables messages to the specified target.

Defaults — The following are defaults for the set log commands.

„Events at the error level and higher are logged to the WX console.

„Events at the error level and higher are logged to the WX system buffer.

„Trace logging is enabled, and debug-level output is stored in the WX trace buffer.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — Using the command with only enable or disable turns logging on or off for the target at all levels. For example, entering set log buffer enable with no other keywords turns on logging to the system buffer of all facilities at all levels. Entering set log buffer disable with no other keywords turns off all logging to the buffer.

Examples — To log only emergency, alert, and critical system events to the console, type the following command:

WX4400# set log console severity critical enable success: change accepted.

See Also

„clear log on page 581

„display log config on page 584