HP Manager Software manual Output for display ap config, Dap

278CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Table 52 Output for display ap config

Field	Description
Port	WX port number.
	Note: This field is applicable only if the MAP is directly
	connected to the WX switch and the WX switch’s port is
	configured as a MAP access port.
DAP	Connection ID for the Distributed MAP.
	Note: This field is applicable only if the MAP is configured on
	the WX switch as a Distributed MAP.
Serial-Id	Serial ID of the MAP access point.
	Note: This field is displayed only for Distributed MAPs.
AP model	MAP access point model number.
POE	PoE state on the WX port:
	„	Enable
	„	Disable
bias	Bias of the WX connection to the MAP:
	„	High
	„	Low
name	MAP access point name.
fingerprint	Hexadecimal fingerprint of the MAP’s public encryption key.
	This field is displayed only for Distributed MAPs. If the field is
	blank, the key has not been verified yet by an administrator.
boot-download-	State of the firmware upgrade option:
enable	„ YES (automatic upgrades are enabled)
	„ NO (automatic upgrades are disabled)
load balancing group	Names of the MAP load-balancing groups to which the MAP
	access point belongs. If the value is None, the access point
	does not belong to any load balancing groups.
	Note: This field is displayed only if the MAP is a member of a
	group.
Radio	Radio number. The information listed below this field applies
	specifically to the radio.
type	Radio type:
	„	802.11a
	„	802.11b
	„	802.11g