HP Manager Software See Also, „clear system on page, „set system name on page, „set system contact on page, „set system location on page, „set system ip-address on page

44CHAPTER 3: SYSTEM SERVICE COMMANDS

Table 7 display system output (continued)

Field	Description
Fan status	Operating status of the WX switch’s three cooling fans:
	„ OK — Fan is operating.
	„ Failed — Fan is not operating. MSS sends an alert to
	the system log every 5 minutes until this condition is
	corrected.
	Fan 1 is located nearest the front of the chassis, and fan 3
	is located nearest the back.
Temperature	Status of temperature sensors at three locations in the WX:
	„ ok — Temperature is within the acceptable range of
	0° C to 50° C (32° F to 122° F).
	„ Alarm — Temperature is above or below the
	acceptable range. MSS sends an alert to the system log
	every 5 minutes until this condition is corrected.
PSU Status	Status of the lower and upper power supply units:
	„ missing — Power supply is not installed or is
	inoperable.
	„ DC ok — Power supply is producing DC power.
	„ DC output failure — Power supply is not producing
	DC power. MSS sends an alert to the system log every
	5 minutes until this condition is corrected.
	„ AC ok — Power supply is receiving AC power.
	„ AC not present — Power supply is not receiving AC
	power.
Memory	Current size (in megabytes) of nonvolatile memory (NVRAM)
	and synchronous dynamic RAM (SDRAM), plus the percentage
	of total memory space in use, in the following format:
	NVRAM size /SDRAM size (percent of total)
Total Power Over	Total power that the device is currently supplying to its
Ethernet	directly connected MAP access points, in watts.

See Also

„clear system on page 39„set system contact on page 54„set system countrycode on page 54„set system ip-addresson page 57„set system location on page 58„set system name on page 58