HP Manager Software manual Syntax set radio-profile name dtim-interval interval

338CHAPTER 9: MANAGED ACCESS POINT COMMANDS

set radio-profileChanges the number of times after every beacon that each MAP radio in

dtim-intervala radio profile sends a delivery traffic indication map (DTIM). An MAP access point sends the multicast and broadcast frames stored in its buffers to clients who request them in response to the DTIM.

The DTIM interval applies to both the beaconed SSID and the nonbeaconed SSID.

Syntax — set radio-profile name dtim-interval interval

„name — Radio profile name.

„interval — Number of times the DTIM is transmitted after every beacon. You can enter a value from 1 through 31.

Defaults — By default, MAP access points send the DTIM once after each beacon.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You must disable all radios that are using a radio profile before you can change parameters in the profile. Use the set radio-profile mode command.

The DTIM interval does not apply to unicast frames.

Examples — The following command changes the DTIM interval for radio profile rp1 to 2:

WX4400# set radio-profile rp1 dtim-interval 2 success: change accepted.

See Also

„display radio-profileon page 298

„set radio-profile mode on page 342