HP Manager Software manual Set radio-profile auth-psk command

348CHAPTER 9: MANAGED ACCESS POINT COMMANDS

Table 67 Defaults for Service Profile Parameters (continued)

		Radio Behavior When Parameter Set
Parameter	Default Value	to Default Value
psk-raw	No preshared	Uses dynamically generated keys rather
	key defined	than statically configured keys to
		authenticate WPA clients.
rsn-ie	disable	Does not use the RSN IE in transmitted
		frames. (The RSN IE is required for
		802.11i. RSN is sometimes called WPA2.)
shared-key-auth	disable	Does not use shared-key authentication.
		This parameter does not enable PSK
		authentication for WPA. To enable PSK
		encryption for WPA, use the
		set radio-profile auth-psk command.
ssid-name	private	Uses the SSID name private.
ssid-type	crypto	Encrypts wireless traffic for the SSID.
tkip-mc-time	60000	Uses Michael countermeasures for 60,000
		ms (60 seconds) following detection of a
		second MIC failure within 60 seconds.
web-aaa-form	Not configured	For WebAAA users, serves the default
		login web page or, if configured, the
		SSID-specific login web page.

wep key-index	No keys
	defined

Uses dynamic WEP rather than static WEP.

If you configure a WEP key for static WEP, MSS continues to also support dynamic WEP.

wep active-	1	Uses WEP key 1 for static WEP encryption
multicast-index		of multicast traffic if WEP encryption is
		enabled and keys are defined.
wep active-unicast-	1	Uses WEP key 1 for static WEP encryption
index		of unicast traffic if WEP encryption is
		enabled and keys are defined.
wpa-ie	disable	Does not use the WPA IE in transmitted
		frames.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You must configure the service profile before you can map it to a radio profile. You can map the same service profile to more than one radio profile.