HP Manager Software manual Wired Authentication Port Details, Vlan membership

92CHAPTER 4: PORT COMMANDS

Defaults — The default tag-list is null (no tag values). The default number of sessions is 1. The default fallthru authentication type is none.

Access — Enabled.

History—Version 3.0: Options added to change the fallthru authentication type. This is the authentication type that MSS uses is the user does not support 802.1X and is not authenticated by MAC authentication. Version 4.0: Option for WebAAA fallthru authentication type changed from web-authto web-portal.

Usage — You cannot set a port’s type if the port is a member of a port VLAN. To remove a port from a VLAN, use the clear vlan command. To reset a port as a network port, use the clear port type command.

When you change port type, MSS applies default settings appropriate for the port type. Table 18 lists the default settings that MSS applies when you set a port’s type to ap.

Table 18 Wired Authentication Port Details

Port Parameter	Setting
VLAN membership	Removed from all VLANs. You cannot assign an MAP access
	port to a VLAN. MSS automatically assigns MAP access ports
	to VLANs based on user traffic.
Spanning Tree	Not applicable
Protocol (STP)
802.1X	Uses authentication parameters configured for users.
Port groups	Not applicable
IGMP snooping	Enabled as users are authenticated and join VLANs.
Maximum user	1 (one).
sessions
Fallthru	None.
authentication type

Examples — The following command sets port 2 for a wired authentication user:

WX1200# set port type wired-auth 2 success: change accepted