HP Manager Software manual Map, WX4400# display dap status

display {ap dap} status 287

display {ap dap} Displays MAP access point and radio status information. status

Syntax — display ap status [terse] [port-list all [radio {1 2}]]

Syntax — display dap status [terse] [dap-num[radio {1 2}]]

„terse — Displays a brief line of essential status information for each MAP.

„port-list— List of ports connected to the MAP access point(s) for which to display status.

„dap-num— Number of a Distributed MAP for which to display status.

„all — Shows status information for all directly attached MAP access points and all Distributed MAP access points configured on the switch.

„radio 1 — Shows status information for radio 1.

„radio 2 — Shows status information for radio 2. (This option does not apply to single-radio models.)

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 3.0. True base MAC addresses of radios are displayed in MSS Version 3.2. Previously, the base MAC address displayed for a radio was the true base MAC address plus 2. Note that a radio’s base MAC address is also used as the BSSID of the first SSID configured on the radio. In Version 4.0, added terse, display dap status: all, new field for fingerprint, and added MAP-WX security status to State field. Note: the fingerprint field and security state apply to the display for Distributed MAPs only.

Examples — The following command displays the status of a Distributed

MAP:

WX4400# display dap status 1

Dap: 1, IP-addr: 10.2.34.56 (vlan 'default'), MAP model: AP2750, manufacturer: 3Com, name: DAP1

fingerprint: b4:f9:2a52:37:58:f4:d0:10:75:43:2f:45:c9:52:c3

====================================================

State: operational (not encrypted)

CPU info: IBM:PPC speed=266666664 Hz version=405GPr