HP Manager Software manual Defaults All WX ports are network ports by default

set port type ap 89

This option does not apply to single-radio models. The value 11g does not apply to model MP-101.

Defaults — All WX ports are network ports by default.

The default radio type for model MP-101 is 802.11b. The default radio type for model AP2750, AP7250, MP-241, and MP-341, and for the 802.11b/g radios in models AP3750, AP8250, AP8750, MP-52, MP-252, MP-262, and MP-352 is 802.11g in regulatory domains that support 802.11g, or 802.11b in regulatory domains that do not support 802.11g.

MAP radios configured for 802.11g also allow associations from 802.11b clients by default. To disable support for 802.11b associations, use the set radio-profile11g-onlycommand on the radio profile that contains the radio.

MAP model MP-262 requires an external antenna for the 802.11b/g radio. You must specify the antenna model. The AP3750 and MAP-3xxmodels have an internal 802.1b/g antenna as well as a connector for an external antenna, so use of an external antenna is optional on these models. The AP3750 and MAP-372 also have a connector for an optional external 802.11a antenna. MAP models MP-341 and MP-352 have an internal 802.1b/g antenna as well as a connector for an external antenna, so use of an external antenna is optional on these models. The AP2750, AP7250, AP8250, and AP8750 models are supplied with detachable antennas which may be replaced by an external dual-mode antenna. To specify the external antenna fitted, use the set {ap dap} radio antennatype command.

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — You cannot set a port’s type if the port is a member of a port VLAN. To remove a port from a VLAN, use the clear vlan command. To reset a port as a network port, use the clear port type command.

When you change port type, MSS applies default settings appropriate for the port type. Table 17 lists the default settings that MSS applies when you set a port’s type to ap.