HP Manager Software manual Set igmp qri, VLANs on a WX

418CHAPTER 11: IGMP SNOOPING COMMANDS

set igmp qri	Changes the IGMP query response interval timer on one VLAN or all
	VLANs on a WX.
	Syntax — set igmp qri tenth-seconds [vlan vlan-id]
	„	qri tenth-seconds— Amount of time (in tenths of a second) that
		the WX waits for a receiver to respond to a group-specific query
		message before removing the receiver from the receiver list for the
		group. You can specify a value from 1 through 65,535.
	„	vlan vlan-id— VLAN name or number. If you do not specify a
		VLAN, the timer change applies to all VLANs.

Defaults — The default query response interval is 100 tenths of a second (10 seconds).

Access — Enabled.

History — Introduced in MSS Version 3.0.

Usage — The query response interval is applicable only when the WX is querier for the subnet. For the WX to become the querier, the pseudo-querier feature must be enabled on the WX and the WX must have the lowest IP address among all the WX switches eligible to become a querier. To enable the pseudo-querier feature, use set igmp querier.

Examples — The following command changes the query response interval on VLAN orange to 50 tenths of a second (5 seconds):

WX1200# set igmp qri 50 vlan orange success: change accepted.

See Also

„set igmp lmqi on page 412

„set igmp oqi on page 415

„set igmp qi on page 417

„set igmp querier on page 419

„set igmp rv on page 420