HP Manager Software manual WX1200# set summertime PDT success change accepted

178CHAPTER 6: IP SERVICES COMMANDS

„min — Minute to start or end the time change — a value between 0 and 59.

„end — End of the time change period.

Defaults — If you do not specify a start and end time, the system implements the time change starting at 2:00 a.m. on the first Sunday in April and ending at 2:00 a.m. on the last Sunday in October, according to the North American standard.

Access — Enabled.

History —Introduced in MSS Version 3.0.

Usage — You must first set the time zone with the set timezone command for the offset to work properly without the start and end values.

Configure summertime before you set the time and date. Otherwise, summertime’s adjustment of the time will make the time incorrect, if the date is within the summertime period.

Examples — To enable summertime and set the summertime time zone to PDT (Pacific Daylight Time), type the following command:

WX1200# set summertime PDT success: change accepted

See Also

„clear snmp usm on page 122

„clear timezone on page 124

„display summertime on page 138

„display timedate on page 138

„display timezone on page 139

„set timedate on page 180

„set timezone on page 181