HP Manager Software manual Clear log, Syntax clear log buffer server ip-addr

21 SYSTEM LOG COMMANDS

Use the system log commands to record information for monitoring and troubleshooting. MSS system logs are based on RFC 3164, which defines the log protocol.

Commands by	This chapter present system log commands alphabetically. Use Table 109
Usage	to locate commands in this chapter based on their use.
	Table 109 System Log Commands by Usage
	Type	Command
	System Logs	set log on page 586
		set log trace mbytes on page 589
		display log config on page 584
		display log buffer on page 582
		display log trace on page 585
		clear log on page 581
clear log	Clears the log messages stored in the log buffer, or removes the

configuration for a syslog server and stops sending log messages to that server.

Syntax — clear log [buffer server ip-addr]

„ buffer — Deletes the log messages stored in nonvolatile storage.

„ server ip-addr— Deletes the configuration for and stops sending log messages to the syslog server at this IP address. Specify an address in dotted decimal notation.

Defaults — None.