set snoop 571

 

The following command removes all snoop filter mappings from all

 

radios:

 

WX1200# clear snoop map all

 

success: change accepted.

 

See Also

 

„ set snoop map on page 574

 

„ display snoop on page 576

 

„ display snoop map on page 577

 

 

set snoop

Configures a snoop filter.

 

set snoop filter-name [condition-list] [observer ip-addr]

 

[snap-length num]

 

„ filter-nameName for the filter. The name can be up to 32

 

alphanumeric characters, with no spaces.

 

„ condition-listMatch criteria for packets. Conditions in the list

 

are ANDed. Therefore, to be copied and sent to an observer, a packet

 

must match all criteria in the condition-list. You can specify up to

 

eight of the following conditions in a filter, in any order or

 

combination:

 

„

frame-type {eq neq} {beacon control data

 

 

management probe}

 

„

channel {eq neq} channel

 

„

bssid {eq neq} bssid

 

„

src-mac {eq neq} mac-addr

 

„

dest-mac {eq neq} mac-addr

 

„

host-mac {eq neq} mac-addr

 

„

mac-pairmac-addr1 mac-addr2

To match on packets to or from a specific MAC address, use the dest-macor src-macoption. To match on both send and receive traffic for a host address, use the host-macoption. To match on a traffic flow (source and destination MAC addresses), use the mac-pairoption. This option matches for either direction of a flow, and either MAC address can be the source or destination address.

Page 571
Image 571
HP Manager Software manual Set snoop, „ set snoop map on, „ display snoop on, „ display snoop map on