Emerson CF160 owner manual Electrical Requirements, How to Assemble Your Ceiling Fan

BP7358 RUSTICO CF160 9/19/07 11:23 AM Page 5

2. Slide the four switch levers on the code switch to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down.

3. In the receiver (Figure 1), slide the four switch levers to the same positions as set in the transmitter. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate.

4. Position the battery in the transmitter battery compartment and replace the battery cover.

CEILING FAN

PROCEDURES

Electrical Requirements

Your new ceiling fan will require a ground- ed electrical supply line of 120 volts AC, 60 Hz, 15 amp circuit.

The outlet box must be securely anchored and capable of withstanding a load of at least 50 pounds.

!WARNING

To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support”, and use screws sup- plied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electri- cian if in doubt.

!WARNING

!WARNING

Turning off wall switch is not suffi- cient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring. All wiring must be in accordance with National and Local codes and the ceiling fan must be properly grounded as a precaution against possible electrical shock.

How to Assemble Your Ceiling Fan

1. Place the motor housing assembly on a flat surface with the top of the motor facing upwards. Place the upper glass over the motor housing assembly, aligning the slots in the upper glass with the mounting holes in the housing flange (Figure 2). Install three 8-32 x 15mm screws, flat washers, and rubber washers (supplied) to secure the assembly.

2. Place the motor housing/upper glass assembly onto the lower foam pad with the bottom of the motor facing you. The lower pad serves as a holder for the fan during the first stages of assembly.

8-32 x 15mm SCREW (3) FLAT WASHER (3)

RUBBER WASHER (3)

UPPER GLASS

MOTOR HOUSING

ASSEMBLY

To avoid possible fire or shock, fol- low all wiring instructions carefully.

Any electrical work not described in these instructions should be done or approved by a licensed electrician.

If your fan is to replace an existing ceiling light fixture, turn electricity off at the main fuse box at this time and remove the exist- ing light fixture.

Figure 2

3. Mount the fan blades to the blade flanges using three 10-24 x 9mm truss head screws and three fiber washers (supplied) (Figure 3).

5 U.L. Model No.: CF160