BP7358 RUSTICO CF160 9/19/07 11:23 AM Page 10
STANDARD |
|
SWITCH OR OPTIONAL SW115 | BLACK |
WALL CONTROL |
TO | BLACK |
(HOT) | |
120- |
|
VOLT |
|
SUPPLY |
|
| WHITE |
| GROUND |
BLACK
WHITE
WHITE
BLACK
CABLE (WITH
GROUND)
GREEN WIRE (GROUND) 
FROM HANGER BALL AND
HANGER BRACKET
Figure 13
BLUE WHITE ORANGE
BLACK
BLUE WHITE
ORANGE
HANGER BALL
3. Push the wires and connectors up into the outlet box while inserting the receiv- er fully into the hanger bracket. Position the antenna wire on top of the receiver.
4. Screw the two
5. Lift the ceiling cover up to the threaded studs and turn until the studs protrude through the holes in the ceiling cover (Figure 13).
6. Secure the ceiling cover in place by sliding lockwashers (supplied) over the threaded studs and installing the two knurled knobs (supplied). (Figure 14). Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling.
CEILING
COVER
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
NOTE: If you wish to operate your ceil- ing fan with the downlight fixture attached, perform steps 7 and 8. Otherwise, skip to step 9.
7. For Operating Your Fan With the Downlight Fixture. Remove the thread- ed plug from the light fitter adapter. Feed the black and white wires of the light fitter assembly through the hole in the adapter and screw the threaded nipple of the light fitter into the adapter hole (Figure 15). Install nut and lock- washer onto threaded nipple inside of adapter and securely tighten.
LOCKWASHER
(2)
KNURLED
KNOB (2)
Figure 14
NUT | LOCKWASHER |
| LIGHT |
| FITTER |
THREADED | ADAPTER |
PLUG |
|
THREADED | LIGHT FITTER |
| |
STUD (2) |
|
Figure 15 | THREADED |
NIPPLE |
10 | U.L. Model No.: CF160 |
