Emerson CF160 Tools Needed for Assembly, Materials, Unpacking Instructions, Up to 50 ft, 50-100ft

BP7358 RUSTICO CF160 9/19/07 11:23 AM Page 3

This Manual Is Designed to Make it as Easy as Possible for You to

Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver One wire stripper

One stepladder

Six wire connectors (supplied)

Three 60-watt (max.) candelabra base bulbs Three 40-watt (max.) cnadelabra

base round bulbs

Materials

Wiring, outlet box and box connectors must be of type required by the local code. The minimum wire would be a 3-conductor (2-wire with ground) of the following sizes:

Installed Wire Length	Wire Size A.W.G.
Up to 50 ft.	14
50-100 ft.	12

Unpacking Instructions

For your convenience, check-off boxes are provided next to each step. As each step is completed, place a check mark in the box. This will insure that all steps have been completed and will be helpful in finding your place should you be interrupted.

!WARNING

Do not install or use fan if any part is damaged or missing. Call Toll-Free:

1-800-654-3545

!WARNING

This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Electric Co. Substitution of parts or accessories not designated for use with this product by Emerson Electric Co. could result in personal injury or property damage.

1. Open styrofoam unit containing fan. Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts:

NOTE: If you are uncertain of part description, refer to exploded view illustration.

a.Fan motor housing assembly

b.One upper glass

c.One ceiling cover

d.One decorative cover

e.Five fan blades

f.Five blade flanges

g.One hanger bracket

h.One hanger ball/downrod assembly

i.One 3-1/2” downrod

j.One decorative cap

k.One finial nut

l.One lower glass

m.One decorative scroll assembly

n.One light fitter adapter

o.One light fitter assembly

p.One remote control transmitter

q.One remote control receiver

r.One loose parts bag, containing:

1.Two 1-1/4” threaded studs

2.Two knurled knobs

3.Two lockwashers

4.Seven wire connectors

5.One hairpin clip

6.One clevis pin

7.Eleven 1/4-20 x 11mm pan head screws with lockwashers

8.Sixteen 10-24 x 9mm truss head screws

9.Sixteen fiber washers

10.Four 8-32 x 12mm pan head screws

11.Three 8-32 x 15mm pan head screws

12.Three #8 flat washers

13.Three #8 rubber washers

14.One nut 1/8 - 27NPS

15.One lockwasher 1/8 - 27NPS

NOTE: Place the parts from the loose parts bags in a small container to keep them from being lost. If any parts are missing, contact your local retailer or catalog outlet for replacement before proceeding.

	UP DN
	HIGH
	MED
e	LOW
	OFF
	REV

						p
	b		j		l
		f			o
			k	m
			h		n	q
a	c	g	i			r
	d
			3			U.L. Model No.: CF160