Emerson CF160 owner manual

BP7358 RUSTICO CF160 9/19/07 11:23 AM Page 6

!WARNING

To reduce the risk of personal injury, do not bend the blade flange when installing the blade flanges, balanc- ing the blades or cleaning the fan. Do not insert foreign objects in between rotating fan blades.

FIBER WASHER (3)	10-24 X 9mm
	TRUSS HEAD
	SCREW (3)
	FAN BLADE

7. Carefully remove the fan motor housing assembly from the lower foam pad. Turn the housing assembly over and position it on the lower foam pad with the fan blades resting on the pad so that the top of the motor faces up.

8. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 5). Remove the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for rein- stallation in step 12.

PIN

BLADE FLANGE	HANGER
	BALL
Figure 3	DOWNROD
	SETSCREW
4. Remove and discard the three shipping
retainers securing the motor hub in the	Figure 5
motor housing.

NOTE: Take care not to scratch the fan housing when installing the blade assemblies.

5. Insert a 1/4-20 x 11mm pan head screw with lockwashers into each of the two recessed holes in one of the blade flanges.

6. Align two of the threaded holes in the motor with the two cutouts in the adapter plate (Figure 4). Position the blade flange on the motor hub so that the screws in the blade flange align with the two threaded holes in the motor hub. Tighten the two screws securely. Repeat this procedure for the remaining four blade assemblies.

ADAPTER

PLATE

CUTOUT FOR

FLANGE SCREW

ACCESS

BLADE

FLANGE

NOTE: If you have an eight-foot ceiling, you will have to use the 3-1/2” downrod (supplied) in order to maintain the nec- essary blade-to-floor clearance of seven feet.

9.Unscrew the two upper setscrews (Figure 6) until they clear the inside of the motor coupling. Then separate, untwist and unkink the four 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 6). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull up on the downrod to make sure the clevis pin is properly installed.

Figure 4	1/4-20 x 11mm PAN HEAD SCREW	6	U.L. Model No.: CF160
	WITH LOCKWASHER (2)