BP7358 RUSTICO CF160 9/19/07 11:23 AM Page 12
Operating Your
Ceiling Fan
IMPORTANT
Fan installation must be completed, including the installation of the fan blades, before testing of the remote control.
Your remote control (Figure 19) has full control of your fan and light.
1. Restore electrical power to the outlet box by turning the electricity on at the service panel.
2. To set the desired fan speed, press the HIGH, MED, or LOW buttons to oper- ate your fan on high, medium, or low speed.
3. To turn your fan off, press the OFF button.
4. To change the airflow direction of the fan blades, press the REV button. The direction the fan blades turn will change each time the REV button is pressed.
5. To turn the downlight on, press and release the DN button. The light will turn on at the light intensity previously selected.
6. To turn the uplight on, press and release the UP button. The light will turn on at the light intensity previously selected.
7. To vary the intensity of the light, hold the DN or UP button down until the desired light intensity is reached, then release the button.
Red light should turn on when any but- ton is pressed. If the light does not come on, replace the battery.
Installation of
Storage Bracket
A storage bracket is supplied with the remote control for holding the transmitter when not in use. If you desire to use the bracket, use the two screws (supplied) and install it on a wall that is away from excess heat or humidity.
UP DN
HIGH
MED
LOWREMOTE
CONTROL
TRANSMITTER
OFF
REV
®
Figure 19
12 | U.L. Model No.: CF160 |
|