BP7358 RUSTICO CF160 9/19/07 11:23 AM Page 7
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrews securely tight- ened. Failure to verify that the pin and setscrews are properly installed (as shown in Figure 5) could result in the fan falling.
tight against the pin and securely tight- en the setscrew in the hanger ball. A loose setscrew could create fan wobble.
| DOWNROD |
GROMMET | DECORATIVE |
HAIRPIN
CLIP
SETSCREW (2) 
Figure 6
DOWNROD
MOTOR
COUPLING
CLEVIS PIN
COVER |
DECORATIVE
SCROLL
ASSEMBLY
10. Tighten the setscrews (Figure 6) secure- ly while pulling up on the downrod.
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
NOTE: If you installed the
11. Make sure the grommets are properly installed in the decorative scroll assembly and in the decorative cover. Slide the decorative scroll over the downrod until it rests on the motor housing. (Figure 7). Then slide the decorative cover over the downrod until it rests on the top of the decora- tive scroll.
12. Place the ceiling cover over the down- rod. Then reinstall the hanger ball (Figure 8) on the downrod as follows. Route the four 80” motor leads through the hanger ball and slide the hanger ball over the downrod. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up
Figure 7
!WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
PIN | HANGER BALL |
CEILING COVER
SETSCREW
DOWNROD
Figure 8
7 | U.L. Model No.: CF160 |
