HP Manager Software manual Set radius client, System-ip, „ clear radius server on

set radius client system-ip 469

„ retransmit — 3 (the total number of attempts, including the first attempt)

	„ timeout — 5 seconds
	Access — Enabled.
	History —Introduced in MSS Version 3.0.
	Usage — You can specify only one parameter per command line.
	Examples — The following commands sets the dead time to 5 minutes,
	the RADIUS key to goody, the number of retransmissions to 1, and the
	timeout to 21 seconds on all RADIUS servers connected to the WX
	switch:
	WX1200# set radius deadtime 5
	success: change accepted.
	WX1200# set radius key goody
	success: change accepted.
	WX1200# set radius retransmit 1
	success: change accepted.
	WX1200# set radius timeout 21
	success: change accepted.
	See Also
	„ clear radius server on page 467
	„ display aaa on page 217
	„ set radius server on page 472
set radius client	Causes all RADIUS requests to be sourced from the IP address specified by
system-ip	the set system ip-address command, providing a permanent source IP
	address for RADIUS packets sent from the WX switch.
	Syntax — set radius client system-ip
	Defaults — None. If you do not use this command, RADIUS packets
	leaving the WX have the source IP address of the outbound interface,
	which can change as routing conditions change.
	Examples — Enabled.
	History —Introduced in MSS Version 3.0.