OPERATION
Before Operation:
Use: This machine is used only for wet or dry sawing of old and new concrete and asphalt.
WARNING!
DO NOT use for dry cutting in European Union (EU) regions. Machine is not equipped with a dust port.
Tools: Use machine only with the following tools (H): Wa- ter Cooled Diamond Blades. Reinforced Abrasive Blades or Dry Cutting Diamond blades should NOT be used with- in European Union (EU) regions because this machine, as supplied, does not include a dust collector port.
Diameter: 300 mm (12”) – 500 mm (20”).
Bore: 25.4mm (1.00”).
WARNING!
DO NOT use carbide, wood saw, or circular saw blades on this machine, else injury or death could oc- cur.
Re-Locating the Blade Guard (C) - If Required:
Blade Guard (C) is factory installed on right hand side of machine, but can be relocated to left side. This may allow cutting closer to obstacles, if approaching them from the opposite direction is not possible.
1.Use 13mm Wrench (U) to remove Blade Guard Rear Bolt (E) from Blade Guard (C).
2.Push back collar to separate Water Hose Disconnect
(G). Male half remains with Blade Guard (C). Female half remains with Water Tank (P) or Water Control Valve (KK).
3.Lift Blade Guard (C) upward, and off of Blade Guard Mounting Spade (Y).
4.Use 13mm Wrench (U) to remove four (4) screws that attach Blade Guard Latch Plate (F).
(C).
5.Remove and relocate Shaft Guard (W) from left hand side of machine to right hand side.
6.Lower Blade Guard (C) onto Blade Guard Mounting Spade (Y) on left hand side of machine.
7.
8.
9.Relocate and realign Front Pointer (A) so Guide Wheel
(B) is on left side of machine.
22
WARNING!
Before operating machine, read and under- stand this entire operation manual & engine operation manual supplied with engine.
Be familiar with machine before operation!
Operator must wear personal protective equipment & cloth- ing appropriate to the work he is doing. Personal protective equipment, such as hearing & eye protec- tion, is mandatory.
