OPERATION
Starting and cutting with machine:
•Using Blade Depth Control (EE), raise Diamond Blade
(H) as high as possible so it will not strike pavement when maneuvering. Pull out on Blade Depth Stop (FF) if required.
•
•With engine OFF, maneuver machine into position near line to be cut.
•Lower Front Pointer (A) onto cutting surface.
•Set Depth Indicator (GG) (use if desired):
1)Lower machine until diamond blade contacts cut- ting surface.
2)Set Depth Indicator (GG) dial to align indicator
arrows with zero (0). Orange color indicates cutting depth in centimeters. White color indicates inches.
3)Raise saw to maximum height. Now as Diamond Blade (H) is lowered, Depth Indicator (GG) will show cutting depth.
4)Fully raise Diamond Blade (H).
Starting FS 513:
•Verify that Emergency Stop Switch (AA) AND Engine Start Switch (DD) are in “ON” position. Emergency Stop Switch (AA) should be in outer position (pulled outward from cowl). Engine Start Switch (DD) must be turned to “1” (ON) position. Travel Speed Lever (QQ) is near the “Stop” position.
•Start Engine by engaging Engine Choke Lever, and pull- ing starting rope.
Starting FS 520 / FS 524:
•Verify that Emergency Stop Switch (AA) is in outer posi- tion (pulled outward from cowl), and Parking Brake (OO) is
•Pull Engine Choke Outward (See engine manual for more information).
•Turn Engine Start Switch (DD) to “Start“ position.
•Start Engine. See engine manual for more information.
After Starting Engine (All Models):
•Visually verify that tool rotation matches directional ar- row on blade guard.
•Open Water Control Valve (KK1) FULL open. Verify full water flow, and then adjust for proper amount of water on the blade BEFORE you lower the Blade.
•Make final adjustments to align saw with cutting line.
Verify that Guide Wheel (B), and Diamond Blade (H) are
both on the cutting line.
26
NOTICE
Parking Brake must be
