ASSEMBLY
Install Front Pointer (A):
1.Using screws, washers and nuts installed in the Front Pointer (A), install onto tube frame of Water Tank Support
(N). Adjust locking nuts to allow Pointer (A) to pivot freely.
2.Route pointer rope to avoid hot surfaces. Two loops in rope allow attachment to Rear Handle (JJ).
Note: “Single Pointer” (A) shown. Some regions have “Dual Pointer” as standard equipment. For all regions, Dual Pointer is available as an accessory. See “accesso- ries” section of this document, or spare parts list for more information.
Blade Guard Front (D):
1.Using 13mm Wrench (U) provided, remove two (2) M8 screws located in front of and below Blade Guard Latch Plate (F), and the M8 screw in Blade Guard Front (D) [as indicated by arrows]. Lossen, but do not remove, remain- ing screw Blade Guard Latch Plate (F). Rotate Blade Guard Latch Plate (F), and Blade Guard Front (D) down- ward.
2.Reinstall three (3) M8 screws in Blade Guard Latch Plate (F) as shown in the diagram at the right. Use the 13mm Wrench (U) (supplied) to securely tighten the four
(4) M8 bolts that hold the Blade Guard Latch Plate (F) in position.
Re-Position Blade Depth Control Handle (EE):
Pull outward on Blade Depth Control Handle (EE) and rotate 90 degrees until is snaps in position shown.
18
WARNING!
Blade Guard Latch Plate
(F)Must Be Installed before operation. Failure to Install before operating machine could create a Hazardous situation!
Always keep all guards in place when operating machine!
