ASSEMBLY
Install Water Tank (P) (if equipped):
•A factory installed water tank is available in some regions. An optional water tank kit is available for all regions.
•If water tank was previously installed on machine, read these instructions to verify that installation is correct. Fol- low all WARNINGS for installation and use of the Water Tank.
•Verify the contents of the Water Tank Kit See Diagram at right.
1.FS 513 Only: Temporarily remove the right hand (same side of machine as engine starter rope) NUT from Lifting Eye (O). See diagram at right.
2.FS 513 Only: Install CLAMP supplied in Water Tank Kit (P), and then reinstall the NUT. See diagram at right.
3.FS 513 Only: Torque as specified below, and diagram at right.
NOTICE
Torque Lifting Eye NUT to 83 N-m (61 lb-ft) mini-
mum.
WARNING!
Torque NUT as specified, else failure of LIFTING EYE
(O)could occur. Injury or death could occur if LIFT- ING EYE fails while lifting machine.
19
