INSPECTION
The package contents:
(1)MINUTEMAN PowerCenter software (floppy disk); (1) Serial interface cable
HOW TO DETERMINE THE POWER REQUIREMENTS OF YOUR EQUIPMENT
1.Make sure that the total
2.Ensure that the equipment plugged into the
3.If the power requirements of your equipment are listed in values other than
proximately 60% of below value to estimate power requirements:
Watts (W) x 1.82 = VA or Amps (A) x 120 = VA
Add the totals for all of the equipment and multiply this total by 0.6 to calculate actual require- ments.
Note: Many factors can affect the amount of power that your computer system will require. The total load that you will be placing on the
Hardware Installation Guide
1.Your new UPS may be used immediately upon receipt. However, charging the battery for at least
2.If you wish to use the software, connect the en- closed serial interface cable to the serial port on the UPS and an open serial port on the computer. If you are not going to use the software, you do not need to connect the cable.
3.With the UPS unit off and unplugged, connect your
computer, monitor, and any externally powered data storage device (Zip drive, Jazz drive, Tape drive, etc…) into the battery power sup- plied outlets. Plug your peripheral equipment (printer, scanner, speakers) into the
4.To protect a fax, phone or modem, connect a telephone cable from the wall jack outlet to the IN jack of the UPS. Connect a telephone cable from the OUT jack to the modem port on your computer. The OUT jack can be used to protect a telephone or fax machine.
2