HP Manager Software manual Set radius, „ set server group on

468CHAPTER 14: RADIUS AND SERVER GROUP COMMANDS

	Examples — To remove the server group sg-77type the following
	command:
	WX4400# clear server group sg-77
	success: change accepted.
	To disable load balancing in a server group shorebirds, type the following
	command:
	WX4400# set server group shorebirds load-balance disable
	success: change accepted.
	See Also
	„ set server group on page 474
set radius	Configures global defaults for RADIUS servers that do not explicitly set
	these values themselves. By default, the WX switch automatically sets all
	these values except the password (key).
	Syntax — set radius {deadtime minutes key string
	retransmit number timeout seconds}
	„ deadtime minutes — Number of minutes the WX switch waits after
	declaring an unresponsive RADIUS server unavailable before retrying
	the RADIUS server. You can specify from 0 to 1440 minutes.
	„ key string — Password (shared secret key) used to authenticate to
	the RADIUS server. You must provide the same password that is
	defined on the RADIUS server. The password can be 1 to 32
	characters long, with no spaces or tabs.
	„ retransmit number — Number of transmission attempts the WX
	switch makes before declaring an unresponsive RADIUS server
	unavailable. You can specify from 1 to 100 retries.
	„ timeout seconds — Number of seconds the WX switch waits for the
	RADIUS server to respond before retransmitting. You can specify from
	1 to 65,535.

Defaults — Global RADIUS parameters have the following default values:

„deadtime — 0 (zero) minutes (The WX switch does not designate unresponsive RADIUS servers as unavailable.)

„key — No key