HP Manager Software manual Snoop map snoop1, Examples display snoop stats filter-namedap-numradio

578CHAPTER : SNOOP COMMANDS

Usage — To display the mappings for all snoop filters, use the display snoop command.

Examples — The following command shows the mapping for snoop filter snoop1:

WX1200# display	snoop map snoop1
filter 'snoop1'	mapping
Dap: 3	Radio: 2

See Also

„clear snoop map on page 570

„set snoop map on page 574

„display snoop on page 576

display snoop stats Displays statistics for enabled snoop filters.

Examples — display snoop stats [filter-name[dap-num[radio

{1 2}]]]

„filter-name— Name of the snoop filter.

„dap-num— Number of a Distributed MAP to which the snoop filter is mapped.

„radio 1 — Radio 1 of the MAP.

„radio 2 — Radio 2 of the MAP. (This option does not apply to single-radio models.)

Defaults — None.

Access — Enabled.

History —Introduced in MSS Version 4.0.

Usage — The MAP retains statistics for a snoop filter until the filter is changed or disabled. The MAP then clears the statistics.